Steps to creating a rock stand (11-14-2010)
           
This is the stone to be displayed A support system was implemented to hold the rock while measuring & aligning Holding the straps in place while not damaging the rock An engine hoist was used to raise the stone Securely held above work table Figuring the proportions for the base Exploring the best stand The right height and angle Identifying the center of balance Using the chop saw to cut stand pieces Aligning stand pieces Top angle support Trimming the top Checking stand fit to rock features Top supports Aligning angle Bottom support Attaching the bottom support Fully assembled Final presentation            
More Art contact Scott                                                                    
BACK